Looking for:
Samsung rf28hfedtsr manual |
- User Manual Samsung RF28HFEDTSR/AA Refrigerator | manualsFile
Refrigerator door handle mounting stud Part DAA. Show More Parts. Bottom-Mount Refrigerator. Electric Range. Samsung Electric Range Parts. Front-Engine Lawn Tractor. Craftsman front-engine lawn tractor parts Craftsman front-engine lawn tractor parts. Furnace Parts Williams. Gas Pressure Washer. Locate the nearest cold water drinking line and install the pipe clamp and shut off valve.
There are several items that you need to purchase to complete this connection. Connect the household water line to the assembled compression fitting. Tighten the compression nut B onto the compression fitting. Do not over-tighten the compression nut B. Turn the water on and check for any leakage.
If you find water drops or leakage in the connection areas, turn off the main water supply. Check the connections and, if necessary, tighten. Flush 1 gallon of water through the filter before drinking or using the water from the refrigerator. Flush approximately 6 minutes. To flush, press a large glass or cup against the water dispenser lever.
Fill the glass, empty it into the kitchen sink after it is filled, and then repeat. After you turn on the refrigerator, let the ice maker make ice for 1 to 2 days. Over that period of time, throw out the first 1 or 2 buckets of ice the freezer makes to ensure all impurities have been removed from the water line. Only connect the water line to a drinkable water source. You can test the water line quickly using a paper cup.
Under normal conditions, the water dispenser can fill a 5. Now that you have your new refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance. By completing the following steps, your refrigerator should be fully operational. Make sure your refrigerator is in an appropriate location with reasonable clearance between it and the wall.
Refer to installation instructions in this manual. Once the refrigerator is plugged in, make sure the interior light comes on when you open the doors. Set the Temperature control to the coldest temperature and wait for an hour.
The freezer will get slightly chilled and the motor will run smoothly. Reset the refrigerator and freezer to the temperatures you want. After you plug the refrigerator in, it will take a few hours to reach the appropriate temperature. You can store food and drinks in the refrigerator after the temperature is sufficiently cool. SAMSUNG is not legally responsible for any damage, including, but not limited to, property damage caused by water leakage from the use of a generic water filter.
The Filter light turns red to let you know when it is time to change your water filter cartridge. To give you time to get a new filter, the red light comes on just before the capacity of the current filter runs out.
Changing the filter on time provides you with the freshest, cleanest water from your refrigerator. Shut off the water supply. If you are having difficulties, grip the water filter firmly and pull it hard. This is normal. To minimize the water leaks, keep the filter cartridge horizontal when you pull it. Removing any residual matter inside the water supply line after installing the water filter.
Turn ON the the water supply if you turned it off when you installed the water filter. Run water through the dispenser until the water runs clear approx.
This will clean the water supply system and remove air from the lines. Open the Refrigerator door and make sure there are no water leaks coming from the water filter. Be sure to flush the dispenser thoroughly, otherwise water may drip from the dispenser. This means that there is still air in the line.
If the temperature of the Freezer and Fridge compartments are too high or low, adjust the temperature manually. Press the Freezer button repeatedly until the desired temperature is shown in the temperature display.
See below. Press the Fridge button repeatedly until the desired temperature is shown in the temperature display. The temperature control process for the Fridge works just like the Freezer process. Press the Fridge button to set your desired temperature. After a few seconds, the Fridge will begin adjusting towards the newly set temperature. This will be reflected in the digital display.
Once the Freezer and Fridge temperature return to their normal set temperatures, the blinking will stop. Try unplugging the appliance, wait for around 10 minutes and then plug the power cord back in. If the blinking continues for a long period of time, please contact a Samsung Electronics Service Center.
Place a glass underneath the ice dispenser and push gently against the dispenser lever with your glass. Make sure the glass is in line with the dispenser to prevent the ice from bouncing out.
Water may overflow or ice may jam the bucket. When the chime sounds, release the Test button. Allow your refrigerator to operate and cool down for 24 hours or 1 full day.
Do not use harsh or abrasive cleaners or solvents. If a power failure occurs, ice cubes may melt, and then freeze together when the power comes back on, preventing the dispenser from working properly.
To prevent this problem, after a power failure, pull out the ice bucket and discard the residual ice or water. The ice maker will make new ice faster after you return the ice bucket to the refrigerator. If you use all the ice at once, you must repeat Steps 2 and 3 under Ice Making. However, only wait 8 hours before dispensing the first 4 to 6 ice cubes. This will replenish the ice cubes and ensure maximum ice production.
If you leave the ice cubes in the bucket, the ice cubes may clump together, making it difficult to remove them. To remove the ice bucket safely and avoid injury, hold the bottom of the bucket with one hand and the side of the bucket with the other. Shut off the water supply. Pull the water filter 1 from the case filter 2. The pressure of the water supply coming out of a reverse osmosis system going to the water inlet 1.
Turn ON the water supply if you turned it off valve of the refrigerator needs to be between 35 when you installed the water filter. Run water through the dispenser until the water connected to your cold water supply, the water runs clear approx. If the water pressure to the reverse osmosis system is less than 40 to 60 psi to kPa : 3. Additional flushing may be required in some households.
Open the Refrigerator door and make sure osmosis system is blocked. If the blinking continues for a long period of Check the water level time, please contact a Samsung Electronics Service Center.
Water may overflow or ice may jam the bucket. To fill the ice bucket to maximum capacity after However, only wait 8 hours before installation, follow these steps: dispensing the first 4 to 6 ice cubes. This will replenish the ice cubes and 1.
Allow your refrigerator to operate and cool ensure maximum ice production. Dispense 4 to 6 ice cubes into a glass. Using the ice off Function 3. After 8, and then 16 hours, dispense a full glass of ice. When you select the Ice Off mode, remove all ice cubes from the bucket. Do not use harsh or abrasive cleaners or To remove the ice bucket safely and avoid injury, solvents. Page 35 Going on vacation Otherwise, water is increased, and the water becomes leakage may occur.
Otherwise, odor and mold may develop. The water may temporarily look misty or cloudy due to these oxygen bubbles. After a few seconds, the water will look clear. If the Vertical Hinged Section is reversed, put it back to the right position and close the door. Moisture may appear at times on the Vertical Hinged Section. The door handle may become loose over time.
If this happens, tighten the bolts found on the inside of the door. This pantry can be used for large party trays, deli 2. There is a temperature control which can adjust This feature helps keep food fresh for a longer the amount of cold air allowed into the pantry.
The control is located on the right side of the 3. This feature also helps keep meat or fish fresh for a longer time. The table below lists the Pantry modes and the kinds of foods that can be stored safely for each mode. Fresh mode is the default. Press the Temp button repeatedly until the mode you want is lit. Page 39 How to use the Multi Supporter 2. Tempered Glass shelves - To remove : Tilt up the front of the shelf in the direction shown 1 and lift it up vertically 2. When not in use, leave the Multi Supporter Pull the shelf out.
Then lower the front of the shelf so that the hooks can drop into the slots. Flip the Multi Supporter to position 1 to prevent items from falling out and over. The Tempered Glass shelves are heavy. Use special care when removing them. If you use the self without removing the Shelf Front, be aware the Shelf Front can separate from the shelf. Flip the Multi Supporter to position 2 to use it as a divider.
Page Using The Doors To remove the door bins 4. Show All Parts. Refrigerator door switch Part DAC. Add to cart. Refrigerator flipper assembly Part DAA. Refrigerator freezer door handle support Part DAA. Refrigerator roller Part DAA.
Refrigerator door hinge bushing Part DAA. Refrigerator freezer door handle end cap Part DAA. Refrigerator freezer door handle Part DAC.
No comments:
Post a Comment